Ring Video Doorbell 2: Wired Install

this video will show you how to install ring video doorbell too if you plan on connecting it to existing doorbell wiring this is the installation you'll do if you want your internal bell to ring when someone pushes the button on the front of your ring video doorbell - this is the battery we recommend fully charging the battery before installation even if your wiring ring to existing doorbell wires wiring your ring

video doorbell - ensures that your internal bell will ring plug the charging cable into the battery while charging both the red and green lights will light up when only the green light is wet it's completely charged slide the battery back into the compartment you'll hear it click when the batteries secure after inserting the battery it'll take about a half a minute for your ring doorbell to power up before installation complete the in-app

setup of your ring doorbell indoors near your Wi-Fi router if you need help to refer to our video on setting up your ring doorbell in the ring up first shut off power is a breaker remove your existing doorbell from the wall and disconnect the wire use your ring doorbell to mark the install location if you're installing ring doorbell on stucco brick or concrete then use the provided drill bit to drill holes into your wall and

insert the included anchors into the hole if you're installing on wood or siding you don't need the anchors and can screw your ring doorbell directly into your wall the optimal installation height for ring doorbell is four feet off the ground if you're installing ring doorbell two existing wires that are higher than four feet use the wedge mount to angle it down to improve your view now connect your existing doorbell wire if your wiring ring doorbell

to existing wires you'll need a transformer with a voltage of 824 volt AC a resistor must be used if your wiring directly to a transformer please note that most intercoms and DC transformers are not supported if your existing doorbell wires are too short to wire the ring doorbell you can use these wire extensions and wire nuts to connect them together to use the wire nuts hold the wires together and twist the wire nuts

clockwise over them until they're secure loosen the screws on the back of your ring doorbell and insert the Spade connectors like this after connecting the wires tighten both screws on the back of ring doorbell to ensure good connection eat your wiring ring doorbell to a digital Bell you'll need to install this diet for more information refer to our video on diode installation you can also refer to the printed manual that came with ring

doorbell if you need help if you have a mechanical Bell do not install the diode because doing so can damage your Bell then feed all the wires and wire nuts if they were used into your wall then secure your ring doorbell using the provided screws afterward install your faceplate by slotting it in at the top and clicking it into place finally use the star-shaped end of the screwdriver to secure the faceplate

with one of the provided security screws turn power back on at the breaker the front light on your ring video doorbell will illuminate congratulations your ring video doorbell is now ready to use

See more here: https://www.youtube.com/watch?v=ooA6KQggrt0

ring doorbell 2 installation brick

this video will show you how to install ring video doorbell too if you plan on connecting it to existing doorbell wiring this is the installation you'll do if you want your internal bell to ring when someone pushes the button on the front of your ring video doorbell - this is the battery we recommend fully charging the battery before installation even ...